Galasource | Service. Period!

Vacuum Package Machine- 18" x 18" x 7" Chamber- (2) 17" Seal Bars by Berkel - #350D

Item Description

Most vacuum packaging machines will do a little more than 2 cycles per minute. Once you determine the width of the open end of the bag, then you can determine how many bags per hour to expect. The bags must lie flat without any overlap. Therefore, if your bag is 6 inches wide and the seal bar is 14 inches wide, then you can place two bags on the seal bar with 2 inches left over. If the bags are 4 inches wide, then you could place 3 bags on the seal bar with 2 inches left over. But if your bag was 7 inches wide, then you could only put on one bag, since 2 times 7 equals 14, and that leaves no room for error. A good rule to follow is to allow about 1-1/2 to 2 inches as a margin of error. With that in mind, a 350D with 2 seal bars of 17 inches could do four 6 inch wide bags at a time. If you expect to run 2 cycles per minute, then 2 times 4 equals 8 bags per minute, or about 480 bags per hour. The size of the pump will speed up or slow down the process. The following chart gives rough numbers based on 6 inch wide bags. (Note: These are approximations but will help you make a decision based on your own circumstance. Also remember that to achieve these results, the product must already be bagged and ready to put into the chamber.) Standard Features

Features

• Models 250, 350, 350D, 450A and 550A feature a stainless steel housing and single chamber
• Model 420A features a stainless steel housing and double chamber
• Seal bar provides high integrity double sealing with electric cut-off
• Vacuum intervals of 1 to 99 seconds
• Gas flush for the addition of an anaerobic gas mixture and/or pillow-pack seal (not available on Model 250)
• Simple to operate electronic, touch pad controls with nine storable programs
• One year limited warranty covers all parts, service and travel, excluding wear items
• View Spec Sheet Model Number 350D